Set Limits for a Configuration Session

The configuration layers and session hosts can be limited when running a Configuration Framework Service (CFS) session.

Limit CFS session hosts

Subsets of nodes can be targeted in the inventory when running CFS sessions, which is useful specifically when running a session with dynamic inventory. Use the CFS --ansible-limit option when creating a session to apply the limits. The option directly corresponds to the --limit option offered by ansible-playbook, and can be used to specify hosts, groups, or combinations of them with patterns. CFS passes the value of this option directly to the ansible-playbook command for each configuration layer in the session. For more information, see the Ansible documentation on Patterns: targeting hosts and groups.

IMPORTANT: The --limit option is useful for temporarily limiting the scope of targets for a configuration session. For example, it could be used to target a subset of the Compute group that has been separated for development use. However it should not be used to limit an Ansible playbook to target only the nodes that the playbook is intended to use. If a playbook should only be run on a specific group, target the proper groups with the hosts: section of the Ansible playbook.

See Using Ansible Limits for more information about limiting hosts and groups in playbooks.

(ncn-mw#) Use the following command to create a CFS session to run on all hosts in the Compute group, but not a previously defined dev group:

cray cfs sessions create --name example --configuration-name configurations-example --ansible-limit 'Compute:!dev' --format json

Example output:

{
  "ansible": {
    "config": "cfs-default-ansible-cfg",
    "limit": "Compute:!dev",
    "verbosity": 0
  },
  "configuration": {
    "limit": "",
    "name": "configurations-example"
  },
  "name": "example",
  "status": {
    "artifacts": [],
    "session": {
      "status": "pending",
      "succeeded": "none"
    }
  },
  "tags": {},
  "target": {
    "definition": "dynamic",
    "groups": null
  }
}

Limit CFS session configuration layers

It is possible to limit the session to only specific layers of the configuration that is specified. This is useful when re-applying configuration of a specific layer and applying the other layers is not necessary or desired. This option may also reduce the number of configurations that need to be created and stored by CFS because sessions can specify layers from a master configuration layer list.

Use the --configuration-limit option when creating a CFS session to apply configuration layer limits. Multiple layers to limit the session are specified as a comma-separated list either by name (if layers were given names when created) or by zero-based index as defined in the configuration submitted to CFS.

(ncn-mw#) Use the following command to create a CFS session to run only on example-layer1, and then example-layer5 of a previously created configurations-example configuration:

WARNING: If the configuration’s layers do not have names, then indices must be specified. Do not mix layer names and layer indices when using limits.

cray cfs sessions create --name example --configuration-name configurations-example \
    --configuration-limit 'example-layer1,example-layer5' --format json

Example output:

{
  "ansible": {
    "config": "cfs-default-ansible-cfg",
    "limit": "",
    "verbosity": 0
  },
  "configuration": {
    "limit": "example-layer1,example-layer5",
    "name": "configurations-example"
  },
  "name": "example",
  "status": {
    "artifacts": [],
    "session": {
      "status": "pending",
      "succeeded": "none"
    }
  },
  "tags": {},
  "target": {
    "definition": "dynamic",
    "groups": null
  }
}