Manage Node Consoles

ConMan is used for connecting to remote consoles and collecting console logs. These node logs can then be used for various administrative purposes, such as troubleshooting node boot issues.

ConMan runs on the system in a set of containers within Kubernetes pods named cray-console-operator and cray-console-node.

The cray-console-operator and cray-console-node pods determine which nodes they should monitor by checking with the Hardware State Manager (HSM) service. They do this once when they starts. If HSM has not discovered some nodes when they start, then HSM is unaware of them and therefore so are the cray-console-operator and cray-console-node pods.

Verify that all nodes are being monitored for console logging and connect to them if desired.

See ConMan for other procedures related to remote consoles and node console logging.

Procedure

This procedure can be run from any member of the Kubernetes cluster to verify node consoles are being managed by ConMan and to connect to a console.

NOTE this procedure has changed since the CSM 0.9 release.

  1. (ncn-mw#) Find the cray-console-operator pod.

    OP_POD=$(kubectl get pods -n services \
        -o wide|grep cray-console-operator|awk '{print $1}')
echo $OP_POD

    Example output:

    cray-console-operator-6cf89ff566-kfnjr

  2. (ncn-mw#) Find the cray-console-node pod that is connected to the node.

    Be sure to substitute the actual component name (xname) of the node in the command below.

    XNAME=<xname>
NODEPOD=$(kubectl -n services exec $OP_POD -c cray-console-operator -- sh -c "/app/get-node $XNAME" | jq .podname | sed 's/"//g')
echo $NODEPOD

    Example output:

    cray-console-node-2

  3. (ncn-mw#) Log into the cray-console-node container in this pod:

    kubectl exec -n services -it $NODEPOD -c cray-console-node -- bash

    Example output:

    cray-console-node#

  4. Check the list of nodes being monitored.

    conman -q

    Output looks similar to the following:

    x9000c0s1b0n0
x9000c0s20b0n0
x9000c0s22b0n0
x9000c0s24b0n0
x9000c0s27b1n0
x9000c0s27b2n0
x9000c0s27b3n0

  5. Compute nodes or UANs are automatically added to this list a short time after they are discovered.

  6. To access the node’s console, run the following command from within the pod. Again, remember to substitute the actual component name (xname) of the node.

    conman -j <xname>

    NOTE The console session can be exited by entering &.