In the event that network plumbing is lacking, down, or unconfigured for procuring devices, then it is recommended to use the Serial/COM ports on the management switches.
This guide will instruct the user on procuring MAC addresses for the NCNs metadata files with the serial console.
Mileage may vary, as some obstacles such as BAUDRATE and terminal usage vary per manufacturer.
Refer to the external support/documentation portals for more information:
Use minicom, screen, or cu to connect to the switch’s console.
A USB-DB-9 or USB-RJ-45 cable is connected between the switch and the NCN.
screenscreen /dev/ttyUSB1
screen /dev/ttyUSB1 115200
minicomminicom -b 9600 -D /dev/ttyUSB1
minicom -b 115200 -D /dev/ttyUSB1
cucu -l /dev/ttyUSB1 -s 115200
On Mellanox switches, if the console is not responding when opened, try holding CTRL + R (or control + R for macOS) to initiate a screen refresh. This should take 5-10 seconds.
If there is no device in /dev/tty*, follow dmesg -w and try reseating the USB cable (unplug the end in the NCN, and plug it back in).
Observe the dmesg -w output. Does it show errors pertaining to USB? The cable may be bad, or a reboot may be required.