The System Admin Toolkit (SAT) is a command-line interface that can assist administrators with common tasks, such as
troubleshooting and querying information about the HPE Cray EX System, system boot and shutdown, and replacing hardware
components. In CSM 1.3 and newer, the sat command is available on the Kubernetes NCNs without installing the SAT
product stream.
It is still possible to install SAT as a separate product stream. Any version of SAT installed as a separate product
stream overrides the sat command available in CSM. Installing the SAT product stream allows additional supporting
components to be added:
An entry for SAT in the cray-product-catalog Kubernetes ConfigMap is only created by installing the SAT product
stream. Otherwise, there will be no entry for this version of SAT in the output of sat showrev.
The sat-install-utility container image is only available with the full SAT product stream. This container image
provides uninstall and activate functionality when used with the prodmgr command. (In SAT 2.3 and older, SAT was
only available to install as a separate product stream. Because these versions were packaged with
sat-install-utility, it is still possible to uninstall these versions of SAT.)
The docs-sat RPM package is only available with the full SAT product stream. You can find SAT documentation at
the links below (see SAT documentation).
The sat-config-management git repository in Gitea (VCS) and thus the SAT layer of NCN CFS configuration is
only available with the full SAT product stream.
If the SAT product stream is not installed, there will be no configuration content for SAT in VCS. Therefore, CFS configurations that apply to NCNs should not include a SAT layer.
The SAT configuration layer modifies the permissions of files left over from prior installations of SAT, so that the
Keycloak username that authenticates to the API gateway cannot be read by users other than root. Specifically, it
it does the following:
Modifies the sat.toml configuration file which contains the username so that it is only readable by root.
Modifies the /root/.config/sat/tokens directory so that the directory is only readable by root. This is needed
because the names of the files within the tokens directory contain the username.
Regardless of the SAT configuration being applied, passwords and the contents of the tokens are never readable by other users. These permission changes only apply to files created by previous installations of SAT. In the current version of SAT, all files and directories are created with the appropriate permissions.
For full SAT documentation, refer to the HPE Cray EX System Admin Toolkit (SAT) Guide.
If SAT has not been installed before, some initial configuration is required (for example, authenticating to the API
gateway with sat auth). To complete the initial configuration of SAT, refer to the following post-installation procedures in the SAT documentation:
If the full SAT product stream is not being installed, it is recommended that you uninstall old versions of the
SAT product stream to avoid confusion in the output of sat showrev. For more information,
refer to SAT Uninstall and Downgrade in the SAT documentation.