Cray System Management Documentation > Cray System Management (CSM) Administration Guide > network > Management Network User Guide > Mellanox Installation and Configuration Guide > Border Gateway Protocol (BGP) Basics

Border Gateway Protocol (BGP) Basics

“The primary function of a Border Gateway Protocol (BGP) speaking system is to exchange network reachability information with other BGP systems. This network reachability information includes information on the list of Autonomous Systems (ASes) that reachability information traverses. This information is sufficient for constructing a graph of AS connectivity for this reachability, from which routing loops may be pruned and, at the AS level, some policy decisions may be enforced.” – RFC 4271A

BGP is configurable to run in either internal (iBGP) or external (eBGP) mode.

(switch(config)#) Enable BGP.
```
protocol bgp
```
(switch(config)#) Configure a BGP instance.
```
router bgp 100
```
(switch (config interface vlan 10)#) Apply IP address to the VLAN interface on router 1.
```
ip address 10.10.10.1 /24
```
(switch (config interface vlan 10)#) Apply IP address to the VLAN interface on router 2.
```
ip address 10.10.10.2 /24
```
(switch(config router bgp 100)#) On BGP router 1:
```
neighbor 10.10.10.2 remote-as 100
```
(switch(config router bgp 100)#) On BGP router 2:
```
neighbor 10.10.10.1 remote-as 100
```

Show commands to validate functionality

(switch#)

show ip bgp summary

Expected results

Administrators can configure BGP on the switch.
Administrators can create the network statements and the routes are in the routing table.
Administrators can configure a BGP neighbor that uses an MD5 encrypted password.
Administrators can validate the BGP relationship is established and that the network statement is advertised to the peer.
Soft reconfiguration is enabled.

Back to Index